46% offClearance · only 1 left! & Large order deal
$15.39Was $28.50
Cactus Rift Japandi Vase
A japandi vase with a rifted surface: a faceted body that catches the light along its ridges and narrows to the rim.
Design by DueMakers
R00420
Formula 1 Wall Art
Decor · Automotive · PLA · 8.9"x1.7"
$1.34Was $1.9932% offBulk deal 4+ & Large order deal
Each, 4 or more in a $30 order. Made to order and ready for pickup in The Orchard, Burlington, ON.
25% off 4+ · $1.49 each once you take 4, in any mix of colour or size.
10% off orders over $30 · taken off the whole order, after the rate above.
Size, colour and licence are chosen in the next step. Nothing is charged until checkout.
A Formula 1 car as flat wall art: the 2024 car cut into a silhouette 2.5 mm thick, with the plane and the rear wing reading from across a room. The designer cuts the long version into pieces for the bigger print; this is the single-piece file, quick enough to print in an evening. Designed by Recticle and printed under Creative Commons Attribution-ShareAlike 4.0 (CC BY-SA 4.0). Shown as a render of the printable model, not a photograph.
Designed by Recticle on MakerWorld · CC BY-SA 4.0 · print only
- Material
- PLA
- Size
- 8.9"x1.7"
- Category
- Decor
- Theme
- Automotive
- Designed by
- Recticle · MakerWorld
- Project code
- R00420
Pickup and payment
Items are reserved for local pickup in The Orchard, Burlington. Cash orders are paid in person at collection; no tax is added.
Pay or reserve first, then choose your pickup time - the exact address comes with your order confirmation.
Questions about this one? Email hello@roxium.ca and quote R00420.
More decor from the shop
46% offClearance · only 1 left! & Large order deal
$8.43Was $15.62
Delicate Decorative Vase
A tall fluted vase, 209 mm high and 79 mm across, printed in vase mode with a single wall so a light behind it shows the ribs. The designer also publishes a two-wall profile if you want it to hold water - say so when ordering and the shop will run that one instead. Designed by Ian and printed under Creative Commons Attribution-NoDerivatives 4.0 (CC BY-ND 4.0), unchanged as published.
Design by Ian
37% offProduct deal & Large order deal
$1.25Was $1.99
Flexy Skelly
A skeleton printed as a chain of flexing segments, rib cage and all, so it dangles, swings and rattles about. 3.1" long, printed in one piece and only a few grams of plastic.
Design by Max
35% offClearance · only 1 left! & Large order deal
$1.34Was $2.09
Fox Collection
One small fox, about 1.7" tall and 1.9" long, head up with its thick tail curled along its side. The designer's plate carries twenty-five copies of this fox, and the listing is for ONE of them - add as many as you want. The plate prints in one go with no supports and no AMS, which is what it was built for.
Design by AkeStudio