46% offClearance · only 1 left! & Large order deal
$15.39Was $28.50
Cactus Rift Japandi Vase
A japandi vase with a rifted surface: a faceted body that catches the light along its ridges and narrows to the rim.
Design by DueMakers
R00416
Spiral Vase with Notch and Base
Decor · Decor · PLA · 4.3"x3.5"
$15.61Was $23.1232% offBulk deal 4+ & Large order deal
Each, 4 or more in a $30 order. Made to order and ready for pickup in The Orchard, Burlington, ON.
25% off 4+ · $17.34 each once you take 4, in any mix of colour or size.
10% off orders over $30 · taken off the whole order, after the rate above.
Size, colour and licence are chosen in the next step. Nothing is charged until checkout.
A spiral vase that stands on its own round base. Lloyd Tapper started from Tru!e's spiral flower pot and then fixed the thing that annoyed him - the vase slid around on the base - by adding a notch under the vase and turning the elevators on the base into cones, so the two move together when you pick the vase up. Both makers are credited on this page. Printed under Creative Commons Attribution 4.0 (CC BY 4.0). Shown as a render of the printable model, not a photograph.
Designed by Lloyd Tapper on MakerWorld · CC BY 4.0 · print only
- Material
- PLA
- Size
- 4.3"x3.5"
- Category
- Decor
- Theme
- Decor
- Designed by
- Lloyd Tapper · MakerWorld
- Project code
- R00416
Pickup and payment
Items are reserved for local pickup in The Orchard, Burlington. Cash orders are paid in person at collection; no tax is added.
Pay or reserve first, then choose your pickup time - the exact address comes with your order confirmation.
Questions about this one? Email hello@roxium.ca and quote R00416.
More decor from the shop
46% offClearance · only 1 left! & Large order deal
$8.43Was $15.62
Delicate Decorative Vase
A tall fluted vase, 209 mm high and 79 mm across, printed in vase mode with a single wall so a light behind it shows the ribs. The designer also publishes a two-wall profile if you want it to hold water - say so when ordering and the shop will run that one instead. Designed by Ian and printed under Creative Commons Attribution-NoDerivatives 4.0 (CC BY-ND 4.0), unchanged as published.
Design by Ian
37% offProduct deal & Large order deal
$1.25Was $1.99
Flexy Skelly
A skeleton printed as a chain of flexing segments, rib cage and all, so it dangles, swings and rattles about. 3.1" long, printed in one piece and only a few grams of plastic.
Design by Max
35% offClearance · only 1 left! & Large order deal
$1.34Was $2.09
Fox Collection
One small fox, about 1.7" tall and 1.9" long, head up with its thick tail curled along its side. The designer's plate carries twenty-five copies of this fox, and the listing is for ONE of them - add as many as you want. The plate prints in one go with no supports and no AMS, which is what it was built for.
Design by AkeStudio