R00405
Tool · Outdoor · PETG · 1.2"x1.2"
Each, 4 or more in a $30 order. Made to order and ready for pickup in The Orchard, Burlington, ON.
25% off 4+ · $1.49 each once you take 4, in any mix of colour or size.
10% off orders over $30 · taken off the whole order, after the rate above.
Size, colour and licence are chosen in the next step. Nothing is charged until checkout.
A hook keeper that clips onto the rod handle and gives a lure somewhere to sit between casts, instead of swinging at the line. Three sizes, for rod handles of three diameters; the designer prints his in PETG and that is what the shop prints here, since this is a part that goes to the water. Designed by bambaxp and printed under Creative Commons Attribution-NoDerivatives 4.0 (CC BY-ND 4.0), unchanged as published. Shown as a render of the printable model, not a photograph.
Designed by bambaxp on MakerWorld · CC BY-ND 4.0 · print only
Items are reserved for local pickup in The Orchard, Burlington. Cash orders are paid in person at collection; no tax is added.
Pay or reserve first, then choose your pickup time - the exact address comes with your order confirmation.
Questions about this one? Email hello@roxium.ca and quote R00405.
$1.34Was $1.99
The little tool for pulling the PTFE tube out of a Bambu A1 hot end without taking the printer apart - slot it behind the collar and lever. 1.7" long, printed in one piece in a minute or two. Remixed by R3DPanda from their own earlier version with a handle.
Design by R3DPanda
$1.34Was $1.99
A hose clamp you print instead of buying: a ring with a screw lug that tightens onto a hose or a duct. Four sizes, measured across the clamp - 33 mm, 40 mm, 60 mm and 88 mm - each printed in one piece. Shown as a render, not a photo.
Design by inhabitworker
$1.49Was $2.20
Three sculpting tools with different ends - a flat blade, a point and a loop - for clay, fondant or plasticine. About 6" long each, printed flat in one piece, so they are light enough to work with for an hour. Shown as a render, not a photo.
Design by Chilly_275
$1.34Was $1.99
A hook remover with a forked end for backing a hook out and a flat end for pushing it through - the tool that means you do not put your fingers near the point. 4.8" long, printed flat in one piece. Shown as a render, not a photo.
Design by eclien
