45% offClearance · only 1 left!
$1.44Was $2.66
JEEP Stanley Straw Topper
A Jeep grille that rides on top of a straw, seven slots and all.
Design by Morganja
3D-printed products and 3MF downloads from Roxium in Burlington, Ontario
32% offClearance · only 1 left!
$1.34Was $1.99
Dog Stanley Straw Topper
A dog's head that sits on top of a straw, ears up and nose forward.
Design by Morganja
32% offBulk deal 4+
$1.34Was $1.99
Snap-On Soda Can Lid and Opener
A lid that snaps onto a standard can and seals it up again between sips, and doubles as an opener when you slip it over the tab and tilt. It is the wider, support-free version, and it fits both the slim and the fat cans the designer built it around - European 202 cans, so if yours is a different can it is worth a quick measure. Light sanding on the slots is the only finishing it asks for.
Design by MakerShed
32% offBulk deal 4+
$1.72Was $2.54
Egg Separator
A clip-on egg separator: crack an egg into the channel and the white runs through while the yolk stays put. 3.6" long, printed in one piece, and it sits on the rim of a cup or a bowl.
Design by user_4069524941
32% offClearance · only 3 left!
$1.34Was $1.99
Reading Ruler & Bookmark
A printable reading ruler with an integrated bookmark pointer. The pointer holds your line while you read and marks your place when the book closes - pick the length that suits your book.
32% offBulk deal 4+
$7.83Was $11.60
Puffer Jacket Pencil Holder
A pencil holder wearing a puffer jacket: quilted panels all round, with a zip, a collar and sleeves running up the sides. It holds pens, pencils, markers, brushes or small tools, and it is sturdy enough to be knocked about a desk. About two hours of printing, and the quilted panels take filament colours well - solid winter colours, pastels, or something loud.
Design by Sitsero
32% offClearance · only 1 left!
$1.34Was $1.99
Bee Stanley Straw Topper
A plump bee that clips onto the top of a straw, wings raised and its stripes cut deep enough to read across a table. It suits the 10 mm Stanley straws, is 1.6" by 1.5", and prints in one piece with no supports.
Design by Morganja
32% offBulk deal 4+
$8.99Was $13.32
Rice Washing Bowl
A bowl for rinsing rice: the water swirls through the grain and pours off the side while the rice stays put, so you stop losing half of it down the sink. Two sizes - 6.9" across and a smaller 4.8" - each printed in one piece, with the drain holes and the pouring lip part of the bowl.
Design by ValeraPerinski
