46% offClearance · 1 left & Large order
$15.39Was $28.50
Cactus Rift Japandi Vase
A japandi vase with a rifted surface: a faceted body that catches the light along its ridges and narrows to the rim.
Design by DueMakers
R00502
Dragon Egg Keychains
Decor · Gifts · PLA · 1.2"
$1.49Was $2.2032% offBulk deal 4+ & Large order
Each, 4 or more in a $30 order. Made to order and ready for pickup in The Orchard, Burlington, ON.
25% off 4+ · $1.65 each once you take 4, in any mix of colour or size.
10% off orders over $30 · taken off the whole order, after the rate above.
Size, colour and licence are chosen in the next step. Nothing is charged until checkout.
Three dragon eggs shrunk to keyring size: one scaled egg on a loop and two smaller ones, each with a hole for a split ring. The scale texture is cut deep enough to read at 30 mm, which is the whole trick at this size, and they print flat with no supports. Three keychains, 11 g the set. Designed by Ebro3dPrints and printed under Creative Commons Attribution-ShareAlike 4.0 (CC BY-SA 4.0), a remix of two designs by Studio YBL. Shown as a render of the printable model, not a photograph.
Designed by Ebro3dPrints on MakerWorld · CC BY-SA 4.0 · print only
- Material
- PLA
- Size
- 1.2"
- Category
- Decor
- Theme
- Gifts
- Designed by
- Ebro3dPrints · MakerWorld
- Project code
- R00502
Pickup and payment
Items are reserved for local pickup in The Orchard, Burlington. Cash orders are paid in person at collection; no tax is added.
Pay or reserve first, then choose your pickup time - the exact address comes with your order confirmation.
Questions about this one? Email hello@roxium.ca and quote R00502.
More decor from the shop
46% offClearance · 1 left & Large order
$8.43Was $15.62
Delicate Decorative Vase
A tall fluted vase, 209 mm high and 79 mm across, printed in vase mode with a single wall so a light behind it shows the ribs. The designer also publishes a two-wall profile if you want it to hold water - say so when ordering and the shop will run that one instead. Designed by Ian and printed under Creative Commons Attribution-NoDerivatives 4.0 (CC BY-ND 4.0), unchanged as published.
Design by Ian
37% offLimited-time deal & Large order
$1.25Was $1.99
Flexy Skelly
A skeleton printed as a chain of flexing segments, rib cage and all, so it dangles, swings and rattles about. 3.1" long, printed in one piece and only a few grams of plastic.
Design by Max
35% offClearance · 1 left & Large order
$1.34Was $2.09
Fox Collection
One small fox, about 1.7" tall and 1.9" long, head up with its thick tail curled along its side. The designer's plate carries twenty-five copies of this fox, and the listing is for ONE of them - add as many as you want. The plate prints in one go with no supports and no AMS, which is what it was built for.
Design by AkeStudio